SUNROM ELECTRONICS

Phototransistor 5mm - Everlight PT333-3C Clear

Internal Photodiode + Amplifier combination feature in 5mm Package

Product Code 3533

Available We dispatch same day if ordered by 1PM (excluding holidays), then courier usually takes 2-5 days.
Quantity Pricing
Quantity :
Price (Discount%)
1-49 :
Rs.7.08/- (0%)
50-99 :
Rs.6.73/- (5%)
100-499 :
Rs.6.37/- (10%)
500-999 :
Rs.6.23/- (12%)
1000+ :
Rs.6.02/- (15%)
Phototransistor 5mm - Everlight PT333-3C Clear
Sunrom Product Code for Ordering:
3533
Phototransistors are photodiode-amplifier combinations integrated within a single silicon chip. These are combined to overcome the major fault of photodiodes: unity gain. Many applications demand a greater output signal from the photodetector than can be generated by a photodiode alone. While the signal from a photodiode can always be amplified through use of an external op-amp or other circuitry, this approach is often not as practical or as cost-effective as the use of phototransistors. The phototransistor can be viewed as a photodiode whose output photocurrent is fed into the base of a conventional small-signal transistor.

Phototransistors can be used as ambient-light detectors. When used with a controllable light source, typically an IRED, they are often employed as the detector element for optoisolators and transmissive or reflective optical switches.

Phototransistor Frequency Response

All silicon photosensors (phototransistors, etc.) respond to the entire visible radiation range as well as to infrared. In fact, all diodes, transistors, Darlingtons, triacs, etc. have the same basic radiation frequency response. This response peaks in the infrared range.

This is why manufacturers offer infrared-emitting diodes. Their goal is to maximize the signal-to-noise ratio, by using an emitter with the best match to the phototransistor response. However, note the response is very broad and virtually any light source will work.

Basically, a phototransistor can be any bipolar transistor with a transparent case. There are some variations provide advantages. For example, a focusing lens can be built into the case for directional sensitivity. Coatings can be applied to block some higher or lower wavelengths. The transistor itself may provide higher gain, or higher frequency, or lower capacitance, etc.

Graph of relative response across the spectrum
3533a.gif
The diagram above illustrates the frequency response of silicon phototransistor junctions, along with the spectral output of an infrared LED.

Simple IR Sensor Circuit

3533b.gif
A phototransistor works just like a normal (NPN) transistor, where the BASE current is multiplied to give the COLLECTOR current, except that in a Phototransistor, the BASE current is controlled by the amount of visible or Infrared light, which is why the device only needs 2 pins.

In the simple circuit above, assuming that nothing is connected to "Vout", the BASE current (controlled by the amount of light) will determine the COLLECTOR current, which is the current going through the resistor. Using Ohm law, V=I*R, therefore the voltage at Vout will move up & down based on the amount of light. You can connect this to an OPAMP to boost the signal or directly to an Analog input of a microcontroller. You will then need to program the ADC unit of your microcontroller to read this analog voltage and use it in your code.

Bestselling Products

Sunrom Electronics & Sunrom Technologies are two companies, that are the foremost online e-commerce stores since 2004, providing innovative embedded systems, components & services. Our aim is to empower you to Make In India. We work closely with electronics manufacturing companies & individuals to understand & solve the challenges faced during production. We do not just sell things, We use them ourselves in our products, and provide you with high quality tested components for trouble free experience.

Pride of India   Google Reviews